MACHINE

F-Serie

MATERIAL

Aluminium Composite Panels (ACP)
APC Brands: Dibond, Alubond, Skybond, ...
Synonyms: Aluminium Composite Boards,
Sandwich Panel, ACM Aluminium Composite Material

ACTIONS AXIS CONTROL

Load function: Roll
Use Router Matt
Install Router

ACTIONS GOPRODUCE

Higher speeds for routing are possible but affects the edge quality. If the speed is set too low, the foam will melt and cause issues.The edge quality is far better if the object is routed in one single pass.
However, this may leave a lot of chips and debris on the table. When routing in two passes, make sure the first pass is already in the
bottom aluminum sheet. If not, the melting foam may cause issues. A cleaning pass is discouraged. The small offset may cause cracking
of the lacquer on the aluminum sheets.

NOTE

Summa Routing systems with universal bits can route aluminum covered foam board, however the wear is rather high. Specialized
(bit) stores have specific bits for aluminum. Some brands other boards with a different alu coversheet thickness
that impact the lifetime of the bit.
Bits that have been routing aluminum should not be used on other materials.

PARAMETERS

Standard Router:


-    Up to 4 mm thick4mm Summa bit [#500-9852]

    1pass

    80 mm/sec,

    25k rpm

    Counter Clock whise


-    > 4 mm :

    4mm Summa bit [#500-9852]

    Multipass

    80 mm/sec,

    25k rpm

    Counter Clock whise


HF Router:


-    up to 4 mm thick:6mm Summa bit [#500-9857]

    1pass,

    120 mm/sec,

    35k rpm

    Counter Clock whise


-    up to 6 mm thick:

    6mm Summa bit [#500-9857]

    1pass,

    100 mm/sec,

    35k rpm

    Counter Clock whise


-    > 6 mm:

    6mm Summa bit [#500-9857]

    Multipass

    100 mm/sec,
    35k rpm
    Counter Clock whise


PICTURE