L Series - Laser Not Working (Properly)

Modified on Fri, 9 Sep, 2022 at 10:05 AM

Possible causes:

 

Laser not cutting at all, only etching the material:

    1. Check the Optics are clean
    2. Check the Lens is fitted correctly - Dome Up
    3. Check the Focus Height is set correctly
    4. Check the laser power in ethos or speed are correct.



Laser Cut is intermittent - dashed lines:

    1. Check the Optics are clean
    2. Check the nozzle aperture is clean - not clogged up
    3. Check the LED lights on the laser tube for any faults.



Laser does not Cut or Etch - No Output:

  1. Check the Chiller is switched on and functioning correctly - water is flowing 
  2. Check the Mechanical Shutter fully opens when Lid is Closed
  3. Check the Laser interlock switch and Laser is Enabled.
  4. Check the LED lights on the laser tube for any faults.



 

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article