The video explains how to clean and adjust the HF collet on the HF milling motor of a F series.
Collet setting process:
In your current system 4041 DC-S with collet C4, your collet set process is as follows:
- Apply compressed air
- Screw in collet with inserted tool or c-lock pin
- Adjust the stroke by loosening the collet ½ turn
- Insert and tighten the set screw to prevent the collet from turning
- Insert tool
- Stop compressed air supply
Attention: The collet is not protected against rotation/loosening if the set screw is not firmly tightened.
Maintenance:
- Clean the collet every week and insert it according to the set process
- During yearly maintenance, it is recommended to replace the collet to ensure the clamping power
https://summamail.sharepoint.com/:v:/s/SummaTechnicalSupport/EUGPdxc7MM5NqEW8WO082U0Bmid8keTwmfGeKr7DphRtQw?e=7k5MaP
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article