S Class 1 - Conversion Kit: How can I change the OPOS parameters on the machine?

Modified on Thu, 16 May at 4:28 PM

Introduction

All Summa Software from the past 10 years that can output Print and Cut (OPOS) data will send it in the header of the file. If this is not happening, you have to set the OPOS parameters manually with Summa Cutter Control 4.

Use the following procedure to set the OPOS parameters manually:

Start Summa Cutter Control 4 and click Tool Properties, which is located under Action List.

Click Media Alignment Settings (1) set the OPOS values (2) and click Apply (3).