The procedure attached will describe how to setup Caldera with the F Series and GoProduce


Minimum revision of Caldera

The driver was introduced in version 12 build 190219. This version did not set the files names

correct for barcode jobs. It used HEX instead of decimal numbers. This was corrected in build

190408. All build from that data can use the produce below for using the Summa GoProduce

driver.

Installation and settings

The installation is same as standard cutter driver installation.

The following steps will help you to add the driver for Summa GoProduce to your Caldera RIP.

This operation has to be done only once. The installation will then be effective for all printers.