Roll Cutter - Software

WinPlot software solutions for Roll Cutters - These solutions are visible for all users visiting our website

INFO - How to setup WinPlot with Dual head?
Working with WinPlot and Dual head S Class 2 will only work for firmware revision up to revision 25. From revision 26 the roll cutter will no longer be a...
Mon, 27 Sep, 2021 at 1:50 PM
INFO - WinPlot displays "Could not open Summa Socket Cutter"
The message will be displayed as a result of not being able to communicate with the cutter using a network interface. This could be because the machin...
Mon, 20 Sep, 2021 at 11:21 AM
ISSUE - Cutter Plug-In for CorelDRAW 202x 64bit
Summa Cutter Tools version 2.16 has not yet been updated to support installing the plug-in for CorelDRAW 202x (in special now CorelDRAW 2021). Until then, ...
Wed, 17 Mar, 2021 at 3:26 PM
Backup Restore procedure S2
This procedure describes how to take a backup of a units mainboard parameters and how you can restore a backup. Required Tools Summa Cutter ControlĀ  ...
Fri, 14 Dec, 2018 at 4:39 PM
DRIVER - SummaSign Driver Installation - WinPlot
This document describes how to install the software necessary to drive a SummaSign (Pro (SL)) series roll-cutter. In case of problems getting the m...
Mon, 4 Oct, 2021 at 9:09 AM
DRIVER - SummaCut Driver Installation - WinPlot
This document describes how to install the software necessary to drive a SummaCut series roll-cutter, and applies to the following models: D15 D520 D6...
Mon, 31 May, 2021 at 3:02 PM
DRIVER - SummaCut SE Driver Installation - WinPlot
This document describes how to install the software necessary to drive a SummaCut SE series roll-cutter, and applies to the following models: D60 D60/U ...
Tue, 21 Sep, 2021 at 9:51 AM
DRIVER - SummaCut R(L) Driver Installation - WinPlot
This document describes how to install the software necessary to drive a SummaCut R(L) series roll-cutter, and applies to the following models: D60R D1...
Tue, 1 Jun, 2021 at 8:47 AM
DRIVER - S One Driver Installation - GoSign
This document describes how to install the software necessary to drive a S One series roll-cutter, and applies to the following models: S1D60 S1D75 S1D1...
Mon, 8 Mar, 2021 at 4:10 PM
DRIVER - S Class 2 Driver Installation - GoSign
This document describes how to install the software necessary to drive an S Class 2 series roll-cutter, and applies to the following models: S2D75 S2T75 ...
Tue, 1 Jun, 2021 at 8:55 AM