F Series - POT Pneumatic Oscillating Tool Knives / Blades

Modified on Fri, 09 Sep 2022 at 09:27 PM

  • 500-9830 : POT Knife Flat Point L20 T0.63
    • General use for materials up to 18mm thick
    • Typical material:  honeycomb board, extruded polystyreen, Isolation, rubber (lower speed)
    • Typical speed: 200mm/sec


  • 500-9830 : POT Knife Flat Point L27 T0.63
    • General use for materials between 18-25mm
    • Typical material: honeycomb board 
    • Typical speed: 100mm/sec


  • 500-9832 : POT Knife Flat Point L20 T1.5
    • More sturdy knife (thicknes of the blade is 1.5mm vs 0.63mm)
    • Material up to 18mm thick
    • Typical material: Corrugated plastid / Polycarobonate , Twinwall plastic
    • Typical speed: 150mm/sec


  • 500-9833 : POT knife Serrated L27 T1.0
    • Serrated knife
    • Material up to 25mm thick
    • Typical material: Soft foams
    • low speed <50mm/sec


  • 500-9834 : POT Knife Point L20 T1.0
    • This knife penetrates deep into mat/conveyor. Therefore an extra protection mat is recommended
    • Can cut smaller details (smaller curves) than standard pot knife (500-9830)
    • Typical material : rubber
    • This knive can cut ACP - Aluminium composite panels, but edge quality is ribbed.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article