DRIVER - SummaCut SE Driver Installation - WinPlot

Modified on Wed, 29 Jun 2022 at 03:28 PM

This document describes how to install the software necessary to drive a SummaCut SE series roll-cutter, and applies to the following models:

  • D60
  • D60/U
  • D60SE
  • D60FX
  • D60FXSE
  • T60
  • D120
  • D140SE
  • D160

Note: It may be necessary to upgrade the firmware of the machine to be able to use the USB port on a Windows 7/8/10 computer, as revision 16 is required for machines having firmware version MD9910.

In case of problems getting the machine up and running, it is best to contact your machine vendor as they can determine whether there is a configuration issue or a technical issue.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article