This document describes how to install the software necessary to drive a SummaCut R(L) series roll-cutter, and applies to the following models:
- D60R
- D120R
- D120RL
- D140R
- D140RFX
- D140RL
- D140RLFX
- D160R
- D160RL
Note:
To be able to use GoSign to drive the cutter, the firmware revision has to be at least on level 039.
To update the firmware of the machine, see the following article:
FIRMWARE - SummaCut R(L) Firmware Upgrade Procedure
In case of problems getting the machine up and running, it is best to contact your machine vendor as they can determine whether there is a configuration issue or a technical issue.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article