F Series - POT Pneumatic Oscillating Tool Knives / Blades

Modified on Wed, 24 May 2023 at 10:34 PM

500-9830: POT Knife Flat Point L20 T0.63

  • General use for materials up to 18mm thick
  • Typical material:  honeycomb board, extruded polystyreen, insulation, rubber (lower speed)
  • Typical speed: 200mm/sec


500-9831: POT Knife Flat Point L27 T0.63

  • General use for materials between 18-25mm
  • Typical material: honeycomb board 
  • Typical speed: 100mm/sec


500-9832: POT Knife Flat Point L20 T1.5

  • More sturdy knife (thickness of the blade is 1.5mm vs 0.63mm)
  • Material up to 18mm thick
  • Typical material: Corrugated plastic / Polycarbonate, Twinwall plastic
  • Typical speed: 150mm/sec


500-9833: POT knife Serrated L27 T1.0

  • Serrated knife
  • Material up to 25mm thick
  • Typical material: Soft foams
  • Low speed <50mm/sec


500-9834: POT Knife Point L20 T1.0

  • This knife penetrates deep into the mat/conveyor. (An extra protection mat is recommended)
  • Can cut smaller details (smaller curves) than a standard pot knife (500-9830)
  • Typical material: rubber
  • This knife can cut ACP - Aluminium composite panels, but the edge quality is ribbed

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article