F Series - Perforation Tool

Modified on Wed, 22 May 2024 at 03:26 PM

The attached document contains in-depth information about the Perforation tool.

Minimum software requirements

  • GoProduce V2.3
  • Firmware Version 39


Using three Tangential modules

In order to use the perforating tool alongside cutting and creasing tools, the addition of a tangential module is required. When using three Tangential modules, the left ADC must be installed. 

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article