In this case the cutter is setup for "Barcode workflow". 

To cancel this "barcode workflow" you will have to set the "Alignment mode" to OPOS X


Please set the "Alignment mode to OPOS X, now it probably is set to "OPOS Barcode".

This can be done with Summa Cutter Control in the User Menu:Or on the Cutter panel:


Follow below procedure to change the "Alignment Mode":

  • Press "Menu"
    ‘KNIFE PRESSURE’ will appear on the LCD.
  • Press "arrow up"
    ‘SYSTEM SETUP’ will appear on the LCD.
  • Press "Enter"
    ‘ACTIONS’ will appear on the LCD.
  • Use "arrow up/down" to scroll through the menu until ‘CONFIGURATION’ is reached.
  • Press "Enter"
    ‘IP CONFIG’ or ‘LANGUAGE’ will appear on the LCD, depending on cutter model.
  • Press "arrow up".
    ‘ALIGNMENT MODE’ will appear on the LCD.
  • Press "Enter"
    ‘*OPOS BARCODE’ will appear on the LCD.
  • Press "arrow left/right" to change this value until ‘OPOS X’ or ‘OPOS XY’ is displayed.
  • Press "Enter"
    ‘*OPOS X’ or ‘*OPOS XY’ will appear on the LCD.
  • Press "Exit" to exit twice to return to normal operations.